MINI R50
1st January, 2021, 09:32 PM
Hi,
I have found some axis on a siemens ms5150. Im not sure how these tie up to the map, I have attached the .ori file, I think the rpm axis is defined from address 7522D and is preceded by the number 16 which I assume means it is 16 x something.
A map that could use this axis could be the ignition map located at address 78930. I have read there could be a table that defines which axis belong to which maps, but i'm not sure were this could be in the dump?
I have found some axis on a siemens ms5150. Im not sure how these tie up to the map, I have attached the .ori file, I think the rpm axis is defined from address 7522D and is preceded by the number 16 which I assume means it is 16 x something.
A map that could use this axis could be the ignition map located at address 78930. I have read there could be a table that defines which axis belong to which maps, but i'm not sure were this could be in the dump?