Jaguar XF2014 - central lock problem

[Manta1600]

Garage replaced the battery and after that central lock stop work - key les work and car start - remote work - but dors wont lock unlock only boot lock work

I programed new key the same situation

I read that this is common problem but can't find how to sort it

Some people wrote that need execute battery replace - Iv done but No succes

other told me that need execute - Imobilisation but on my Autel this function is not active

Can someone help with this?

[fred77]

Have you got JLR SDD ?

Reconfiguration/calibration of drivers door module
Or run "Security -immobilisation" in service functions

Worse case replace Central Junction Box (CJB) and Auxiliary. Junction Box (AJB).

Here you go -
https://static.nhtsa.gov/odi/tsbs/2019/MC-10159478-9999.pdf

[momogsm]

Hi

Definitly Yes, What Say Fred77 Is The Solution Of Your Problem, You Should Have JLR SDD, Or Another Diag That Support This Function, But Mostly Only JLR SDD Support It

Good Luck

[Manta1600]

Can someone give me link for good SDD

[momogsm]

Can someone give me link for good SDD
Hi

You Should Have Also VXDIAG Or J2534 Passthru Interface To Can Work With JLR SDD,

Regards

[Manta1600]

Hi

You Should Have Also VXDIAG Or J2534 Passthru Interface To Can Work With JLR SDD,

Regards

Just instaled V160 and conected with cheap Passthru interface that I use for Toyota and looks like work

Tomorrow will try on the car if not work will order better JLR passthru interface

[Manta1600]

Today tried on the car - Read the VIN - OK but after that can't work

[momogsm]

Hi

I Think It's Interface Issue, Use Good Quality Of J2534 Passthru Interface, To Can Perform The Operation, I Use AVDI For It And It's Work Perfect.

Regards

[Manta1600]

Hi

I Think It's Interface Issue, Use Good Quality Of J2534 Passthru Interface, To Can Perform The Operation, I Use AVDI For It And It's Work Perfect.

Regards

Yes Ordered VXdiag

[Manta1600]

Today connected with Autel VCI work fine

Made Imobilzation and only drivers door start work - After that I tried to make recalibration on passenger door and now car is dead

No ignition

Will create new thread about this