AKL problem Polo 6r

[owari]

hello

i have try to make key on all key lost on VDO NEC + 24Cxx ( polo 6r 2010 ) .
I have used Avdi with ZN059 cable i have try several time to enter in service mode. ( impossible to enter ).
But now instrument cluster is like sleeping or still in boot mode.
All is black only have brake red light flashing and 10 second later battery + temperature light flashing.

I have try all solution but impossible to wake up instrument cluster.

thanks for your help !

[super jumbe]

hello

i have try to make key on all key lost on VDO NEC + 24Cxx ( polo 6r 2010 ) .
I have used Avdi with ZN059 cable i have try several time to enter in service mode. ( impossible to enter ).
But now instrument cluster is like sleeping or still in boot mode.
All is black only have brake red light flashing and 10 second later battery + temperature light flashing.

I have try all solution but impossible to wake up instrument cluster.

thanks for your help !

Have tried battery reset!

[owari]

i'm working on bench

[sdnatlst]

there is a boot pin on this cluster, no need for service mode, use VVDI 2 and hold ground pin from something on the certain pad when turning on cluster, it will allow read of full immo data, search pq25 cluster pinout on google it will show you

[owari]

i have try to enter in service mode with boot pin but it's same impossible to enter in service mode and black cluster

[Weasel3]

Maybe try a different tool.
And check out how it behave.

Maybe some colleague in your area.
Can try to make a reading.
If you drive and deliver, on the bench.

[owari]

Maybe try a different tool.
And check out how it behave.

Maybe some colleague in your area.
Can try to make a reading.
If you drive and deliver, on the bench.


I have try with AVDI and VVDI 2 , cluster is like sleepy mode impossible to wake up it . I have buy new cluster i will check if it's hardware or software problem. thanks for your help :)

[owari]

No one have same problem ?

[honingkoning]

I stopped using this method for some reason does not work always as it suppose to.

Read eep and see how it looks like, you can easy read this with Uusp in circuit.

And make service mode by eeprom to see what will happen.

You might be able to read immo data when modifieng eep and in worst case you can transfer this to a donor dash.

Good luck

[owari]

I stopped using this method for some reason does not work always as it suppose to.

Read eep and see how it looks like, you can easy read this with Uusp in circuit.

And make service mode by eeprom to see what will happen.

You might be able to read immo data when modifieng eep and in worst case you can transfer this to a donor dash.

Good luck


yes i have do that because ned is dead but when i want to programming ( add key ) with avdi he tell me put ID88 chip ^^" . But i need to programme ID48 . I will try with VVDI2 .