Ym15 Vito lishi

[Ecuprog31]

Hi all
I’m searching a lishi ym15 with 10 cut for ignition old vito I’ve one with 8 cut
Thanks

[comizelu]

Hi all
I’m searching a lishi ym15 with 10 cut for ignition old vito I’ve one with 8 cut
ThanksNever done one but as far as I know you can't decode the ignition, just door lock.

Sent from my MI CC9 Pro Premium Edition using Tapatalk

[Ecuprog31]

In door 8 cut in ignition 10

[Manta1600]

In door 8 cut in ignition 10

Yes must decode 8 cut from door lock and after that use Insta to see what cuts are possible for other 2 cuts

[joker01]

Is it possible to disassemble, open the ignition cylinder and read wafers or is it complicated???
I'm only bringing the ignition lock...

[davorOS]

you need to turn cylinder then You can turn cap and disassemble

[rob h]

Like Davaros tells you:

Here some details:

If the car is with transpondersystem, remove reading coil first.

Then you can turn the steel lock bezel, freely about 20degrees.
Turn the bezel, to the right these free turning 20degr.. then use wrench pliers, to turn this bezel, 90degrees. and when you get to the 90degr, pull, and the bezel.

If the core, is still stuck, in position 0.
You can try to push tyraps, allong the sides, tp puch shims inwards, and then turn core to position 2, and pull out core.

Or cut a key, 8 cuts correct, and on each key, you can file 2 different codes, on upper position,
A 1,5 2.5 and 3.5 Will open a 1 2 3 4 cut, with a little jiggle.
if ittruns, leaves a mark, file down. If turn free, after jiggle, you cut to deep.

-------------------------------------------
I just read shims, from a door lock.
Cut the 8 known ( and could use insta) to get the 2 first cuts closes to grip.
And use a impresionning technique. On the ignitionlock.
Make the edge, like a knives edge,so it will leave a decent mark.

[joker01]

thanks for the info...as soon as I have everything, if I can't I'll post some photos.....
Akl situation....