corsa D 1.3 Z13DTH ecu replaced with Z13DTJ ecu P0090-06 after program

[sdnatlst]

hi all i replaced above ECU and coded with OPCOM MJD603

now car cranks but no start with fault code P0090-06 fuel pressure regulator short to ground

i think becasue i swapped with z13dtj this car thinks it has a sensor it actually doesnt


does anyone know the fix? does anyone have Z13DTH full backup i can write?

if i write just MPC and FLASH but leave EEPROM programmed as it is now, will it then start the car?

[macmateusz]

Here you have a DTH pm pass

[tango]

you could just bdm the old ecu you have then copy everything to the new ecu
you dont need the eprom file from the bdm dump above, you need your eprom dump from your cars ecu
because this holds the cars immo etc

[Panathaole]

Post both ecus info, or upload ecus label...