Audi A4 RB4 DASH swap system not ok

[Vuk031]

Hi to all,

i have problem a replacement dash AUDI A4 2003 RB4.
i have old Dash and car can start, when i change dash i cant adapt new dash.
I have old pin and new pin.

i tried this too, but when i put ecu pin in dash in block says sys not ok.
[Select]
[17 - Instruments]

[Login - 11]
For the following procedure, use the PIN of the "Donor Pin" which you wrote down earlier.
4-digit PIN
Enter zero followed by the 4-digit PIN directly in the Login field. For example, if your PIN is 1234, enter 01234.
[Do it!]

*Next select

[Adaptation - 10]
Enter 050 in "Channel Number".
[Read]
For the following procedure, use the "Original PIN" number you wrote down earlier.
4-digit PIN
Enter zero followed by the 4-digit PIN directly in the New Value field. For example, if your PIN is 1234, enter 01234.
[Test]
The values may change to "32000", this is normal
[Save]
[Done, Go Back]
[Close Controller, Go Back - 06]
Switch OFF the ignition and let the car sit for ~1 minute, then switch ON the ignition again.
Verify that the REPLACEMENT (NEW or USED) instrument cluster now shows the VIN/IMMO-ID of the vehicle now.

[bendzji]

the car has diesel engine? The adaptation thru channel 50 doesn't for me on them also. I copy Immo data from cluster to cluster manually.

Maybe try to wait 10 minutes on ignition ON and then start the procedure