Pavlin
19th February, 2021, 08:23 PM
Hello everyone. After installing new rear axle sensor I decided to calibrate them using Delphi DS150. I initiated the calibration, did everything the instructions said and when it told me to put it to HIGH level I did and after pressing OK i recieved an error. After checking what the error was it gave up ECAS 3012. I am using a 4x2 control unit. Everything on the control unit worked. After the error the "working position" button no longer works. Any suggestions? How do i recalibrate the sensors back to factory levels? Reading live data and moving the sensors does not change anything. They show 3354mm. Thanks in advance :)