Log in

View Full Version : Golf V Visteon strange PIN


Fec001
4th March, 2021, 02:27 PM
Hi!
I read eprom through OBD and check pin in calculator and shows 832.
Then I read PIN from ECU SIMOS71 OBD and PIN is the same.
rafal
4th March, 2021, 02:41 PM
so try to type 00832
Fec001
4th March, 2021, 04:38 PM
Can someone transfer immo data from Original dump to this "New" dump please?
For some reason, adapting "new cluster" with vcds by pin codes doesn't work.
rubin_miki
4th March, 2021, 04:48 PM
Here is transfered immo data,if need adapt keys pin is 00832
Fec001
4th March, 2021, 08:43 PM
Here is transfered immo data,if need adapt keys pin is 00832

Not working. Look dtc, even adapting not workinghttps://uploads.tapatalk-cdn.com/20210304/15f1c580d88326e9639965ec9cac79ac.jpg
https://uploads.tapatalk-cdn.com/20210304/5bf716cdc1659999c8a038feae86aa91.jpg
lukasz12345
4th March, 2021, 08:53 PM
Which channel you chose.

17?
25?
lukasz12345
4th March, 2021, 08:55 PM
You have selected channel 25


Select channel 17
Fec001
5th March, 2021, 08:40 AM
Impossible to adapt immo data from channel 17 Instruments. Even pin doesn't accepted
lukasz12345
5th March, 2021, 08:57 AM
Impossible to adapt immo data from channel 17 Instruments. Even pin doesn't accepted

Does channel 25 accept an immo Pin?
rubin_miki
5th March, 2021, 09:16 AM
Before you enter pin in adaptation in channel50 leave ignition 10 minutes,then enter pin and try to see what will be
Fec001
5th March, 2021, 09:59 AM
Does channel 25 accept an immo Pin?

Yes channel 25 immo accept pin
Fec001
5th March, 2021, 10:33 AM
Before you enter pin in adaptation in channel50 leave ignition 10 minutes,then enter pin and try to see what will be

Yes I tried to wait until dashborad writes immobilizer adaptation active and after immobilizer active but channel 50 doesn't accept pin. Very strange.
rubin_miki
5th March, 2021, 01:18 PM
and pin in ecu is same?
Fec001
5th March, 2021, 01:39 PM
Yes ofc, double checked that too. connect to ECU and give pin(00832), its accepted.

Other option:
Original cluster has error message on dash, I checked leds on pcb, swap pcb dials from another, try recalibrate km, try to make km 0 by dump and write km with VCDS, try correct chk with codecard soft, nothing helped......
Any other chance to repair error message?
Because I think "new" cluster has some problem with immo adapting. I tried immo adapting with original cluster and thats worked like a charm......