RNS 310 + vcds (vag-com)

[ashes]

hi everyone

i've attached a new RADIo/NAVIGATION to my SEAT LEON 1P (2007), wich already has a Bluetooth Kit.

When i connect vcds 805.0, i can read this fault codes

19-CAN Gateway -- Status: Malfunction 0010
37-Navigation -- Status: Malfunction 0010
56-Radio -- Status: Not registered 0001

Detailed info below:

-------------------------------------------------------------------------------

Address 19: CAN Gateway Labels: 1K0-907-530.lbl
Part No SW: 1K0 907 530 L HW: 1K0 907 951
Component: J533__Gateway H15 0180
Revision: H15 Serial number: 1400K076010366
Coding: E9807F064004020202
Shop #: WSC 04941 785 00200

1 Fault Found:
01044 - Control Module Incorrectly Coded
000 - -
Freeze Frame:
Fault Status: 01100000
Fault Priority: 1
Fault Frequency: 1
Reset counter: 48
Mileage: 47767 km
Time Indication: 0
Date: 2000.00.00
Time: 08:32:24

-------------------------------------------------------------------------------
Address 37: Navigation
Cannot be reached
-------------------------------------------------------------------------------
Address 56: Radio
Cannot be reached


Can anyone help me with this ?
I need to enable my Navigation system so i can use vcds to program it ...

I want to enable the Telephone key, so i can access my mobile phone agenda

[aminebot]

Verify diagnostic lines from gateway to radion. , verify Vcc and Gnd of Radio. (use schematic from Elsawin).
if diagnostic lines and VCC/GND are correct it must be a defective radio.

[ashes]

Verify diagnostic lines from gateway to radion. , verify Vcc and Gnd of Radio. (use schematic from Elsawin).
if diagnostic lines and VCC/GND are correct it must be a defective radio.


If i install the older radio, i can connect to it via CAN.

With the new radio (navigation) i can't reach the radio.

They are using the same connectors, and the pins for CAN (high&low) are the same.

This is strange

[aminebot]

If i install the older radio, i can connect to it via CAN.

With the new radio (navigation) i can't reach the radio.

They are using the same connectors, and the pins for CAN (high&low) are the same.

This is strange

radio/navigation module is defective

[ashes]

radio/navigation module is defective


No ...

I just updated do 812.4 and now i can "see" RNS 310 and i can long coding it.

Just need to find the ECU maps for this controller, so i know waht i'm coding.

thanks

[aminebot]

No ...

I just updated do 812.4 and now i can "see" RNS 310 and i can long coding it.

Just need to find the ECU maps for this controller, so i know waht i'm coding.

thanks

it is impossible that 805 soft can not connect with RNS310 and that 812 can.