Dacia Duster 2018 mb96f6a6

[junmab]

Hi chaps.

I need to clone a cluster of Dacia Duster 2018 with MB96F6A6.
For this purpose i intend to use my UUPROG-s (original).
I searched DK for the relevant pins of UUPROG-S but could find only the pinout of the MCU.
Can someone help me with the output pins of UUPROG-S i have to connect to the MCU ?
Or maybe soldering points on the PCB...

Which memories i should copy for cloning (Flash A SAS,Flash A lower,Flash A upper) ?

Thanks for your help.

[junmab]

Comevon guys. No one can share the connection of upa to mb96f6a6 ?
If it was in the uuprog help library i wouldn't have to ask.

[marina_rv]

47,48 - Tx,Rx
51 = Vcc
51 = Vss
52 = DEBUG
54 = MD
60 = Reset

[junmab]

47,48 - Tx,Rx
51 = Vcc
51 = Vss
52 = DEBUG
54 = MD
60 = Reset

Very funny marina_rv. You always upload the pins of MCU (i searched for your previous answers of course) while i need the outpins of UUSP-S hat connects to the pins in your list.
I could not find any where a list contains the relation of the 9 pins connector of the UUSP to mcu MB96F6A6.
To be more specific MD pin of the MCU goes to what pin of UUSP ?
BTW the numbers in the list you upload are not corresponded to the MCU pins titles as in the MB96F6A6 datasheet. For example: you wrote MD as pin 54 while it is suppose to be pin 64, Reset 60 suppose to be pin 70 etc.
But thanks any way for your reply as no one else is answering, while i can tell people had read this mcu with UUSP-S and uploaded the data files for correcting the miles here in DK...

[junmab]

Problem solved. Job was done.
I would like all uusp-s users to know what i didn't know, but thanks to the reply from Elrasoft support now i can easily find all mcus pinouts:
After choosing the mcu type, open the connection tab then press for pinout and you'll get the diagram.

[sparkle]

good tip !

thank you