Log in

View Full Version : IMMO off golf4 2.8



zuzulic
16th March, 2021, 03:09 PM
Hi guys,

If anyone can help me, I'll appreciate :)
I have the following situation: ecu 022906032BG from golf IV 2.8.
I want to immo off it, so I read the 5p08c3 eeprom with neoprogrammer 2.1.0.16 (read as st95c08, because 5p08c3 wasn't available in ic list).
The resulted dump it's attached bellow. Can anyone verify if the retrieved binary is consistent and if so, immo off it, please ?
I will attach also the dump read as 95080 (it's pretty much the same, only shifted to the right with one byte).

I have doubts regarding the binary, because I'm not sure which is the good one, 95c08 or 95080 ?
Maybe your better experience can conclude which is the good one. And if so, is it posible to write it back to 5p08c3 eeprom using st95c08 writing method in neoprogrammer or should I use 95080 method?

If non of above will result in a correct write, which eeprom should I buy to write the dump ? (I assume that there are other equivalent newer eeproms ?)

A lot of questions from my side, sorry for that but I hope I'll solve them here, thank you !

Cheers

Gammoudi
16th March, 2021, 03:21 PM
TEST AND REPORT

zuzulic
16th March, 2021, 03:32 PM
Thank you for your help. I have successfully wrote the dump to eeprom.
Now I'm still working on modifying the engine.
As soon as everything will be on place, I'll try the flashed eeprom and I'll be back with feedback :)

Cheers !

BeimaST
16th February, 2023, 05:40 PM
happened? tell me how to remove immo

rafal
16th February, 2023, 05:43 PM
happened? tell me how to remove immo

in hex editor + 1 then -1 - it is solution if help for you