patrickmk3
21st March, 2021, 01:41 AM
hello everyone,
i never get sx9 keys the are not used alot here i think.
but today the first one was there.
so i put the correct clamp on the device and decode the key.
all is well so far.
than i cut the key did go good also.
but than i try the key and there is the first problem.
its not working like it should be.
fully inserted not possible to turn the lock of the door or ignition.
if you pull it back the smallest bit than it works.
so i put the newly cut key in the device and try to decode it but that fails because of the decoder misses the blade by a hair.
and than error on decoder.
i never used the clamp do i need to make adjustments to it or ?
i tighten the blade than i put the back piece against the key and tighten that one to.
is this correct way or ?
also i use flip key blade nr 83 is this a problem maybe ?
who can help me out ?
is there any trick i dont know of or
greetings,
patrick
i never get sx9 keys the are not used alot here i think.
but today the first one was there.
so i put the correct clamp on the device and decode the key.
all is well so far.
than i cut the key did go good also.
but than i try the key and there is the first problem.
its not working like it should be.
fully inserted not possible to turn the lock of the door or ignition.
if you pull it back the smallest bit than it works.
so i put the newly cut key in the device and try to decode it but that fails because of the decoder misses the blade by a hair.
and than error on decoder.
i never used the clamp do i need to make adjustments to it or ?
i tighten the blade than i put the back piece against the key and tighten that one to.
is this correct way or ?
also i use flip key blade nr 83 is this a problem maybe ?
who can help me out ?
is there any trick i dont know of or
greetings,
patrick