Immo and keys

[matik185]

Hi friends
What tool should I buy for renew key / reading PIN etc. to start my trip with keys ??

I found X HORSE Key ToolMax ..Is it worth ??
Thanks for reply ! :)

[Manta1600]

The question must be - What Tool$$$$$ must buy

With one tool you can't start also you will need cuting machine and minimum 1 year learning

[matik185]

I understand..
I would like to start to renew used key, clean them and add to car - sell for others.
Next step after year of learning I can think for cuting machine etc ;)

[usman295]

https://www.mk3.com/mk3-key-unlocking-and-programmer
this is nice tool but expensive you can find similar tools for unlocking from china they are cheap but not support all remote keep that in mind above tool also have limits
http://blog.vvdishop.com/xhorse-vvdi-key-tool-renew-and-unlock-user-manual/
can check this also

[castin]

Barracuda, Keytool, pcfprog, vvdiprog for key
Tango, vvdi2, sometime tmpro2 for pin, key programm
few service tool for car, when bricked some module
nice solder skill, many programmer
If You want start in PL, need min 50kPLN.

[matik185]

Barracuda, Keytool, pcfprog, vvdiprog for key
Tango, vvdi2, sometime tmpro2 for pin, key programm
few service tool for car, when bricked some module
nice solder skill, many programmer
If You want start in PL, need min 50kPLN.

Thanks for reply..

What do you need everytime to extract PIN ?

[Weasel3]

Yes I agree.
I think maybe the best thing to do.
Is to start with old PCB's from computers found on the junkyard.
And just learn how to remove. Clean and solder back.
EEPROM, microprocessors.

Its free. Dont need expensive equipment.
Low cost is OK. But need adjustable temperature, on the solder iron.
And then need a lot of practice.
And low cost set of solder tools.
Start with this a couple of months.

And then move on to junkyard locks.
dismantle into pieces.
Many different models, from different cars.
Work with this for a while. Its low cost.

After this, its OK to look at the rest.
And maybe get a programmer, or something.

[matik185]

Yes I agree.
I think maybe the best thing to do.
Is to start with old PCB's from computers found on the junkyard.
And just learn how to remove. Clean and solder back.
EEPROM, microprocessors.

Its free. Dont need expensive equipment.
Low cost is OK. But need adjustable temperature, on the solder iron.
And then need a lot of practice.
And low cost set of solder tools.
Start with this a couple of months.

And then move on to junkyard locks.
dismantle into pieces.
Many different models, from different cars.
Work with this for a while. Its low cost.

After this, its OK to look at the rest.
And maybe get a programmer, or something.

Many thanks for advice but already working with airbags units etc.. :)