Ajdin1
25th May, 2021, 07:23 AM
Hello there, im having problems with this BMW.
A friend of mine bought the car 6months ago, and it was stock, everything fine. Car is in good condition, so he went to a nearby dude to make a stage1 remap.
Car drove fine for 1 day, and than started to report railpressure problems.
I wrote back stock file, and car was fine for 2 3 days, and again railpressure.
I checked cr valve, replaced with new one, railsensor new, injectors tested all good.
So, after a bit of time, we head to do the CP3 conversation, all good
Cp3 runing, new intank and supply pump installed, but stil rail pressure,
Rail is from e60 bmw, injectors 2 sets, one original, second 212 injectors, tested on bench good.
i tried almost everything,but still the same.
If i lower railpressure to 1150 the car is not making problems, when stock rail map, the car reached 1350 but than pcv goes from 65 to 95% and rail starts droping, but no shutdown of car, just limp mode..
Its killing me, can somebody try to make a stage 1 map ? Also car has fited 3bar map sensor, 180, 500, 3000, 3300 that is what i used for scaling,
Railpressure sensor 0 0 1800 1800
I ll attach ori
A friend of mine bought the car 6months ago, and it was stock, everything fine. Car is in good condition, so he went to a nearby dude to make a stage1 remap.
Car drove fine for 1 day, and than started to report railpressure problems.
I wrote back stock file, and car was fine for 2 3 days, and again railpressure.
I checked cr valve, replaced with new one, railsensor new, injectors tested all good.
So, after a bit of time, we head to do the CP3 conversation, all good
Cp3 runing, new intank and supply pump installed, but stil rail pressure,
Rail is from e60 bmw, injectors 2 sets, one original, second 212 injectors, tested on bench good.
i tried almost everything,but still the same.
If i lower railpressure to 1150 the car is not making problems, when stock rail map, the car reached 1350 but than pcv goes from 65 to 95% and rail starts droping, but no shutdown of car, just limp mode..
Its killing me, can somebody try to make a stage 1 map ? Also car has fited 3bar map sensor, 180, 500, 3000, 3300 that is what i used for scaling,
Railpressure sensor 0 0 1800 1800
I ll attach ori