Nissan Primera 1.8L 2006r immo off with Julie emulator

[danyguit2000]

Hi all,
Nissan Primera 1.8L petrol / 2006r.
ECU MEC37-030 (with CAN)
Eeprom 93C66

Because car is far from me i cannot work directly, but with somebody remotely...
Purchased Jullie emulator v110 (Renault) which also supports MEC37-xxx.
On bench seems immo is adapted, but when connected to the car does not even crank.
Also starter was directly sorted, but does not start....
Any comments why is that ?


https://youtu.be/63NFmX1-0vk

[okura]

how DTC code stored? P1610 ?

[volodin69]

Because julie is capable do immo emulation only on mec37 1.4. Maybe i am wrong...

[danyguit2000]

The car is in another town, so i have no idea what is the DTC.
Problem is that car starts ok with the key and runs fine, but once you turn off engine and try to start, it does not, have to wait 15-30min. then you can start again and everything repeats over again...
Perhaps i can try to disconnect CAN L and reconnect it after 1 second like EDC15 (Renault) video...

[danyguit2000]

I finally went to the car and situation is as fallows:


If i register the key car starts without problem, if i cycle the key about 3 times
car does not start, if i register the key back again all perfect until i cycle the key in ignition,
even i managed to register a remote control, but looks like BCM does not remember the key and the remote.
I took the BCM with me, eeprom is 93C66 . BCM (Siemens) looks ok, no water damage , perhaps eeprom gets corrupted...
In ECU code stored P1615


PS: Original electronic 7936 does not exist, but used a normal 7936 transponder