fuzz1
18th June, 2021, 04:14 AM
If you bought a clone iprog and it's not working then try that instead of throwing it away.
Open it and if you are unlucky it would be filled with epoxy.
Remove the board from the casing and place the glued board in an oven. Temperature set to around 200 degrees C.
Let it heat up for around 10 minutes. Then get it out and use a heat gun to heat the small power board. With the help of some scaler pull the power board away.
Now find the threads on here written by psacars and xlv60 to fix the non working power board.
Hope it helps.
Open it and if you are unlucky it would be filled with epoxy.
Remove the board from the casing and place the glued board in an oven. Temperature set to around 200 degrees C.
Let it heat up for around 10 minutes. Then get it out and use a heat gun to heat the small power board. With the help of some scaler pull the power board away.
Now find the threads on here written by psacars and xlv60 to fix the non working power board.
Hope it helps.