AUDI A4 BOSCH DASH 24C08 MILEAGE

[Panathaole]

Hi

i need to set the mileage in a dump from an Audi a4 2002 with bosch E0920900 cluster

now i have 00

and i need 278880....

i edit the line 60 with all 16 44, but is wrong, mileage is correct but i lost info from dush, and mileage doesn't change...

thanks...

[slavik]

Hi try in line 60 9344

[armi]

Hi. If cluster is new mode, first need to adapt to car, adapt keys and then millage can be simple set with vcds.

[al70]

give this a try, goodluck

[Panathaole]

i already have try that, it doesn't work...

i have correct mileage in lcd but it can't increase....

maybe is a dashboard problem....

thanks....

[armi]

Hi, if you correct mileage with vcds , you must switch off all power to cluster and after reconnecting it show new mileage.
Correcting by file not working because mileage is stored in crypted part of eeprom.

[houdiag]

Hi

i need to set the mileage in a dump from an Audi a4 2002 with bosch E0920900 cluster

now i have 00

and i need 278880....

i edit the line 60 with all 16 44, but is wrong, mileage is correct but i lost info from dush, and mileage doesn't change...

thanks...

Try this file, good luck
new km 278880 km
login :3142
818855

Don't forget to reply to us

[Panathaole]

Hi, if you correct mileage with vcds , you must switch off all power to cluster and after reconnecting it show new mileage.
Correcting by file not working because mileage is stored in crypted part of eeprom.

With vcds i get error when i try to edit mileage

And speedometer doesn't work, maybe this donor cluster have problem...

[brend]

Correct!.........


Hi. If cluster is new mode, first need to adapt to car, adapt keys and then millage can be simple set with vcds.

[armi]

Before KM setting you may need login with adaption code 13861. Km can bee set with vcds only once and if new cluster show 0-50 km. If KM is higher, you can use Vageeprompr....1,19 or carprog. If speedometer do not work, check codding and adaption ch 60,61,62. And audi clusters can have two variants of receiving speed data, from speed sender or by CAN . No variants switch it with vcds. It can be done by little change of eeprom only. Ask, if you need more info.

[volodin69]

If speedo stays up, not on zero (and no light on displays), somewone written back the eep without exiting the new mode or decrypted eep.

[Panathaole]

Before KM setting you may need login with adaption code 13861. Km can bee set with vcds only once and if new cluster show 0-50 km. If KM is higher, you can use Vageeprompr....1,19 or carprog. If speedometer do not work, check codding and adaption ch 60,61,62. And audi clusters can have two variants of receiving speed data, from speed sender or by CAN . No variants switch it with vcds. It can be done by little change of eeprom only. Ask, if you need more info.

I try in channel 60,61,62,63 at instrument, and i have error, nothing there...