View Full Version : KA1C-57K30 mazda CX5
fuzz1
21st September, 2021, 05:50 PM
Hi
I am looking for some help to clear this ecu for a Mazda CX5
KA1C-57K30
Chip infineon XC2336-56f
All three files read with UPA-USB-s
Thanking you in anticipation
slavik
21st September, 2021, 06:03 PM
Hi try and report
Pass in PM
If I helped, please use reputation+thanks button
fuzz1
27th September, 2021, 06:02 PM
Hi
I just tested it in the car and unfortunately having issues.
There is one fault U3000:49-D0 CMDTCs control module.
Any idea what could be causing that problem? Is there any way to solve this fault?
Thanks
svenin53
27th September, 2021, 06:07 PM
Need to replace the BOSCH or Atmel Driver.
Photo of unit board please
fuzz1
27th September, 2021, 06:32 PM
837138
Hi
Here it is
svenin53
27th September, 2021, 07:09 PM
Check drivers on board, look closely with microscope and check, any time burn a little hole in driver and this need to change.
Regards))
fuzz1
27th September, 2021, 07:31 PM
I did not find any burn marks on the drivers.
I will look again. I guess if ever it's burnt it would require a driver which would be difficult to find and probably require a new board.
Anyone can possibly try to clear the original file again? maybe it was not cleared properly. the error U3000:49 was not present when i first scan the car before i worked on it.
svenin53
27th September, 2021, 07:43 PM
If no one help you, i tried it tomorrow
fuzz1
28th September, 2021, 08:23 AM
Hi!
Can anyone please check the cleared files? It's giving U3000:49 fault.
Could it be something wrong with the dump?
Thanks
svenin53
28th September, 2021, 09:37 AM
Here you file
jordiksvk
28th September, 2021, 10:43 PM
please could smbdy clear crah data?
thanx wery much...
jordiksvk
30th September, 2021, 06:55 AM
i want to test smthing in the car.... thanx....
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.