cas4 killed vvdiprog

[tomekdr]

I read cas4 using vvdiprog 5M48H. I only read without unlocking. after reading the cas returned to the car. The car does not respond to the key, to the start stop button. I did a car test with istaD. I can't connect to cas. if my dflash and pflash are bad. cas4 5WK50722NBR

[castin]

vvdiprog read w/o problem this cas. Somebady must repair your file and check connection.

[keyselberti]

read again your flash and check for any change on flash. some times ( when vvdi gives error on reading procedure ) changes flash file.

[tomekdr]

I read so. I do not understand how vvdiprog could kill cas with the reading itself. I did not upload anything to it

[keyselberti]

i dont know mate but its possible sometimes :/
and if you conect coexial cables wrong, you can read-write the cas but cas is dead when you conecting on car, be careful for coexial cables

[brend]

I read cas4 using vvdiprog 5M48H. I only read without unlocking. after reading the cas returned to the car. The car does not respond to the key, to the start stop button. I did a car test with istaD. I can't connect to cas. if my dflash and pflash are bad. cas4 5WK50722NBR


Flash bad!

Here good one , write this one and don't forget report about resaults!

[tomekdr]

yes the pflash file was corrupted. After uploading it, everything works again as it should. Now only esys coding. Thank you very much.

[brend]

yes the pflash file was corrupted. After uploading it, everything works again as it should. Now only esys coding. Thank you very much.


If d-flash ok no need coding.

Just update p-flash put this to car job done, that's it!

[dvdtrmbl]

May I get password for this flash please

[mjoesen]

Flash bad!

Here good one , write this one and don't forget report about resaults!

Could I get password to file please?

[fytfh]

i have same problem with vvdi prog and same cas can you give me password please

[tiocojonudo]

Could I get password to file please?