CyGaN
14th October, 2021, 06:08 PM
Hi.
I have a Colt with a airbag light on.
The story was as follows, the computer showed error B1419 Acceleration sensor on the front left side - open circuit. The cube was hanging loose (cube different from the sensor, black-orange and orange-black wires).
I replaced the cube with the one in the sensor (yellow cube with white-blue and black-blue wires), soldered wires orange-black with white-blue and black-orange with black and blue.
After this operation and connecting the sensor, error B1417 Acceleration sensor (G) on the front left - low voltage, the error cannot be deleted.
Aku fully charged and an additional charger connected, the error does not disappear.
Checked connection, pin 1 of the sensor plug now the white and blue cable has a transition to pin 20 of the ABS controller plug in the tunnel (MR587759 DPSCB) and pin 2 of the plug now black and blue has a transition to pin 21 of the controller plug
PMR587419 sensor replaced, same symptoms.
Any ideas ?
The question ... is it possible to try to change the cables in the sensor places, will they not crash the pillows? and the second question; on the other hand, there is a PMR587418 sensor and the cube is connected to it as it was originally on this side, are both sensors compatible and the pinology is the same?
Regards
I have a Colt with a airbag light on.
The story was as follows, the computer showed error B1419 Acceleration sensor on the front left side - open circuit. The cube was hanging loose (cube different from the sensor, black-orange and orange-black wires).
I replaced the cube with the one in the sensor (yellow cube with white-blue and black-blue wires), soldered wires orange-black with white-blue and black-orange with black and blue.
After this operation and connecting the sensor, error B1417 Acceleration sensor (G) on the front left - low voltage, the error cannot be deleted.
Aku fully charged and an additional charger connected, the error does not disappear.
Checked connection, pin 1 of the sensor plug now the white and blue cable has a transition to pin 20 of the ABS controller plug in the tunnel (MR587759 DPSCB) and pin 2 of the plug now black and blue has a transition to pin 21 of the controller plug
PMR587419 sensor replaced, same symptoms.
Any ideas ?
The question ... is it possible to try to change the cables in the sensor places, will they not crash the pillows? and the second question; on the other hand, there is a PMR587418 sensor and the cube is connected to it as it was originally on this side, are both sensors compatible and the pinology is the same?
Regards