Subaru Forester 2011 93c76 need change mileage

[artureq3]

Hi friends need change mileage Subaru Forester 93c76 read eprom 16bit

old km:162511
new:198123

thanks for help

[rafal]

eeprom bad readed....................read as x8

[artureq3]

8bit read eprom

[Cllau]

here... :wink:




Hi friends need change mileage Subaru Forester 93c76 read eprom 16bit

old km:162511
new:198123

thanks for help

[nasbadboy]

Hi friends need change mileage Subaru Forester 93c76 read eprom 842193

old km:212843
new:137340

thanks for help

[clusters]

here............

[nasbadboy]

hi
could you please check if my data was ok vehicle displays blank and does not start
thank you

[rafal]

clusters not doing mistakes................. check you soldering on pcb first

[nasbadboy]

hi

perfectly soldered do you have the powerup pin outs to test on bench

thank you

[nasbadboy]

hi guys could 16bit cause this issue ? if i wrote 8 bit vise versa?
thanks

[rafal]

can be..........................

[nasbadboy]

hi could some one convert this to 16bit ? 842813
might have read 8bit ?
thank you

[jomberykaso]

hi guys could 16bit cause this issue ? if i wrote 8 bit vise versa?
thanks


never read this eeprom in 8 bits, your file is good, probably it is bad soldered or eeprom is reverse

[nasbadboy]

thank you sir :( just cannot see what went wrong

[MileageAudit5]

thank you sir :( just cannot see what went wrong

Did you read this "in circuit" on the board? That could be your problem. Try writing your original file back. That should get the car started hopefully. Speed needle might not work again though...... Good luck.