Nissan Primera 05 Mileage Correction

[justy22]

Hi all

Can anyone tell me how to correct the mileage on an 05 plate Primera

[BestElectrical]

read the memory and post the dump and we will help :)

[justy22]

I have tacho universal i was wondering how i connect the sw13 cable to the back of the cluster

[justy22]

anybody tell me how to connect tacho universal to Primera 05

[raf0468]

if you dont have connection from behind open and remove needles to locate eeprom...

[treo]

Remove the cluster and open it.

�� Look for the 8 pin chip 93C66.

�� Remove this chip from the board.

�� Connect the clip to port 0.

�� Put the clip on the chip 93C66 (RED on pin 1)

�� Select the menu Nissan-Primera2002.

�� The DIGI-Consult shows you the old value.

�� Select the menu Adjust KM.

�� Enter the new value.

[drpeter]

Remove the cluster and open it.


��

Look for the 8 pin chip 93C66.

��


Remove this chip from the board.

��


Connect the clip to port 0.

��


Put the clip on the chip 93C66 (RED on pin 1)

��


Select the menu Nissan-Primera2002.

��


The DIGI-Consult shows you the old value.

��


Select the menu Adjust KM.

��


Enter the new value.


Algo type 1 or 2?

[treo]

Car type: Nissan All vs Miles - 93c66
The mileage is stored in the next lines:
0060: xx xx xx xx xx xx xx xx 3C 7B 78 F6 F1 EC EB D9
0070: 3F FE 7A F6 F5 EC xx xx xx xx xx xx xx xx xx xx
where the next bytes:
3C 7B 78 F6 F1 EC EB D9 3F FE 7A F6 F5 EC - is a mileage

[justy22]

can i solder the sw13 cable to the ports on the back of the cluster

[dashradio]

If you have the picture use it, if not strip the right hand dial out to find the 93c66, will probably read wild miles, check dump if it looks OK, save it then change to new value. job done. It will have taken you longer to write your posts than it will take to strip and do the job.

[justy22]

If you have the picture use it, if not strip the right hand dial out to find the 93c66, will probably read wild miles, check dump if it looks OK, save it then change to new value. job done. It will have taken you longer to write your posts than it will take to strip and do the job.


Can i read the chip with it still on the board, another problem is my small clip is'nt wired correct can anybody send me a diagram of the correct way to wire it

[dashradio]

If it's the clip end just pull out the pins then put them back in starting bottom left pin1 then work clockwise around the clip from pin 1,
8765
1234
the cable wires are left to right pin 1 marked,
= 1,8,2,7,3,6,4,5

If it the D way end just check your SW13 or DIL clip and resolder as they are.

WHY DO YOU START NEW POSTS FOR THE SAME THING ?