Audi a3 1.8T auq ME7.5 need help with stage 1

[costyrzv]

Can someone help with stage 1 for this file ? I have very few info on this ecu yet and I want to compare original file with moded file aswell as writing a good stage 1 on the car . Car is pretty much stock with 3" exhaust and k&n air filter in original housing .

am trying to get to understand this learning on s4wiki and nefmoto but I can't figure it out yet . If someone is available to answer a few questions would be great .

Thanks

[Johnsy1998]

Poat your ori file

[Tunerfreak]

post file i can help

[costyrzv]

Sorry, here it is . I forgot to add the file .

[gomku]

Its here stage 1

[costyrzv]

pass please?

[costyrzv]

So, flushed the file and car is pulling worse than stock . I tried my own file and seems like its pulling somehow stock. I will post the file if someone wants to give me some help . This ecu seems so complicated :(


I think fuelling it's all over the place but here it is. waiting on some thoughts.

[gomku]

Car is pulling worse than stock? spark plug, coil, what condition? If you've read s4wiki, comment the advance table.

[costyrzv]

I flushed ori file back on, car was pulling alright, like it should. Car is running right, starting right and all . Car was converted from auto to manual if you think that is relevant . Iridium spark plugs with stock coils .

[costyrzv]

Its weird, I looked up in kfmirl and kfmiop in your file , torque request is the same as the file I made, might be a vac issue ? Maybe turbo is not building boost properly ? It's doing 0.6 0.7 on gauge on stock file .

[gomku]

changes = kfmdmx, nmax, kflbts, kfkhfm, ldrxn, kfldhbn, kfldimx, kfmiop, kfzwop,kfzwop2, kfmirl, kfzw.


no reason to make it worse.

[costyrzv]

changes = kfmdmx, nmax, kflbts, kfkhfm, ldrxn, kfldhbn, kfldimx, kfmiop, kfzwop,kfzwop2, kfmirl, kfzw.


no reason to make it worse.

makes no sense to me either, I did the same maps as you did..might have to look at the car, maybe you could double check the values on yours.

[gomku]

Can you get the real-time data and upload it here?

[costyrzv]

I'll flush your file tomorrow if I get the time and do a LOG with VCDS and post it here, if not tomorrow definetly on thursday.
What values would you like to see ?

[gomku]

boost (actual and specified), timing advance, maf, engine speed, lambda (target,desired), engine load, WGDC

[costyrzv]

Car is decat, should I try and do lambda off ? Lambda is still on the pipe .

[gomku]

i mean afr

[costyrzv]

%
boost (actual and specified), timing advance, maf, engine speed, lambda (target,desired), engine load, WGDC
Turns out that actually had a bunch of errors stored and the speedometer is not actually working, deleted the errors and car was pulling . It's strage that with stock file it was pulling harder than the tuned file with errors stored lol