View Full Version : Pcm flash boot cable
dehacko
20th November, 2021, 01:35 PM
Hello
I have scanmatic 2pro original, and i need pcm boot cable.
Is possible use cable from powerbox? It is same or not?
For module 71
848952848952
immokill
20th November, 2021, 04:17 PM
Use it
it is same cable module 71 is BOOT option .
Regarfs
dehacko
20th November, 2021, 04:51 PM
ok thank you
But i must have to too plug in cable 14p600kt06 for GPT1 and GPT2
al70
20th November, 2021, 05:41 PM
gpt pinout on top of the box
dehacko
20th November, 2021, 08:03 PM
For module 71 for old power ktm box with 14p600kt06 GPT cable. I set 3,3 V or 5V?
edc17 dimsport pinout GPT0_ grey (GPT1blue) =
14p600kt06 cable GPT1_yellow (GPT2 orange) correct?
figani
20th November, 2021, 08:28 PM
For module 71 for old power ktm box with 14p600kt06 GPT cable. I set 3,3 V or 5V?
I donīt know....
edc17 dimsport pinout GPT0_ grey (GPT1blue) =
14p600kt06 cable GPT1_yellow (GPT2 orange) correct?
YES...
datapage
20th November, 2021, 09:13 PM
gpt1=rotation sensor
gpt2=rotation fase
all ecus...
all programers, Kess, ktag, genius, autotuners etc..
tks+ rep =ok
datapage
20th November, 2021, 09:28 PM
cable scamatick2 pro for pcmflash , ok
obd2=
1=gpt1
2=gpt2
4-5 gnd
6=can
7=k
14=can
16=12v
tks+ rep =ok
dehacko
21st November, 2021, 07:48 AM
I found on google: k-tag set 3,3V, pcm flash 5V
But I don't know if that is 100% true. Try on old ecu both Voltage (3,3 . 5), and report to you
datapage
21st November, 2021, 06:29 PM
if car has rotation sensor 3v =3v
if car has 5v=5v rotation sensor.
remember we used rotation and phase pins
but gpt1-2 output is from the scanmatick interface. Not from the powerbox.
pcmflash auto adjust gpt voltage
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.