2010 astra h mileage correction and cluster swap

[misterwasp77]

i tried to correct the original cluster without success and now suspect the eeprom is damaged. i have a dump of the 080dowq chip which had 122000 ish miles on. bought a replacement cluster from ebay this one has 108001 miles but the car cuts out after 10 seconts and wont crank again unless i fit old clocks which are damaged. could anyone tell me if immobilizer data and vin from old dump can be moved to new one? also the old clock dumped in km and new one in miles.

[jomberykaso]

original file has 244368 kms (151843 miles) , there is not VIN inside, there is not PIN ......file looks like shit, only mileage string looks good.

new file looks normal.

[misterwasp77]

Car runs with old instrument cluster and old eeprom cuts out with new instrument cluster and new eeprom and then wont crank until i fit old instrument cluster and eeprom

[misterwasp77]

Can someone get the security pin from the astra new 108000 eeprom dump please. I think i need to code them to my car but need pin from new clocks

[pawel7924]

try pin 3920

[misterwasp77]

Im looking on my launch and it has no way to install pin to new cluster. The vin is different on old clocks. Is there a way to put old vin and security code onto new 108000 miles dump?
Old sec code is 2874
Old vin W0L0AHL3592142857

[brend]

Im looking on my launch and it has no way to install pin to new cluster. The vin is different on old clocks. Is there a way to put old vin and security code onto new 108000 miles dump?
Old sec code is 2874
Old vin W0L0AHL3592142857

Righ away !

For programm new login you need first reset actual login away then for programming use new login and also rewrite vin , and all job obd2 away no problem .

My option for this job op_com or GM2 .

About launch......:dontknow:, try and report .

[sebage]

Try this...................
I have no idea if it will work, I have not tried such a change yet.

[misterwasp77]

how can i use opcom to reset actual login away. when i connect new cluster to the car it asks me to enter security code for instrument cluster which i dont have for used cluster

[miroopel]

pin new IPC 3920. Read post 5

[misterwasp77]

Opcom says incorrect pin

[miroopel]

Security wait time???

[misterwasp77]

Says 10 min but security wait time was only active after inputting wrong security pin

[misterwasp77]

Where do i find pin from eeprom dump. I have a different vehicle. Which lines and bytes