Problem syncro Ford Focus 1.8 tdci ecu SID202 dash 9S12h256

[daten]

Hi, I'm laying ECU-DASH synchro problem on Ford Focus 2005 - DTC B2139, P1602.
The engine does not turn, I have the synchronization software and once the eeprom of the ECU is synchronized the engine starts to turn but does not start. After several attempts to start the engine everything returns as before, the engine does not turn only contact terminal 15. Check the eeprom 95320 and it has lost synchronization again.
Someone with Ford experience could help me.
Is it possible that the ecu is faulty?
Attached reading eeprom ecu and dash
Thanks

[kiszka]

Hi, I'm laying ECU-DASH synchro problem on Ford Focus 2005 - DTC B2139, P1602.
The engine does not turn, I have the synchronization software and once the eeprom of the ECU is synchronized the engine starts to turn but does not start. After several attempts to start the engine everything returns as before, the engine does not turn only contact terminal 15. Check the eeprom 95320 and it has lost synchronization again.
Someone with Ford experience could help me.
Is it possible that the ecu is faulty?
Attached reading eeprom ecu and dash
Thanks

https://mega.nz/file/A24z0QQA

[daten]

https://mega.nz/file/A24z0QQA


Thanks mate but it doesn't work
Could someone else provide information?
Thanks

[rafal]

can be ecu bricked.......................

[kiszka]

Thanks mate but it doesn't work
Could someone else provide information?
Thanks

you did not specify anything else except that it does not work
you didn't even read errors from ecu and dash
so I don't know what to do because I'm not a fairy

[daten]

you did not specify anything else except that it does not work
you didn't even read errors from ecu and dash
so I don't know what to do because I'm not a fairy

Hello, can you read the first post post enough information also DTC.

[rafal]

Hello, can you read the first post post enough information also DTC.

ok...........but:
when you wrote kiszka's file - is it same situation as post #1 ?
and same dtc's ?

[kiszka]

Hello, can you read the first post post enough information also DTC.

when you checked my files the errors were the same or other dtc

[daten]

when you checked my files the errors were the same or other dtc

I appreciate your help, of the two files you sent me, one was the same as mine. I wrote the eeprom file new.V1 which was different but the motor does not spin.
The question is should I sync the ecu, why did you only send me the eeprom file of the dashboard?
The eeprom of the ecu is out of sync, should I sync with your file?

[daten]

Anyway, I will start all over again and publish the results with dtc reports.

[daten]

Thank you very much to all and especially to kiszka.
Problem solved!
The error was mine, I had to rewrite the eeprom ECU and the eeprom V1 dash from kiszka and the car started without problem.
DTC: none


Regards

[kiszka]

Thank you very much to all and especially to kiszka.
Problem solved!
The error was mine, I had to rewrite the eeprom ECU and the eeprom V1 dash from kiszka and the car started without problem.
DTC: none


Regards

you see, how would i know you made such a mistake
that you gave a different file than you had in ecu