Mazda 6 2010 Mileage correction Digiprog 3 4.94

[KarlEstoni]

Hi everyone!
I did mileage correction on a Mazda 6 2010 with Digiprog 3 4.94 via chip (desoldered it and then soldered back). Now after putting it back in the car the abs, traction and some other lights are on.
Could the Digiprog corrupt the eeprom or maybe i could just have some flux residue left which is just causing the lights to be on?

And if the eeprom is corrupted, could i use a dump from another car or immo information is stored on the same chip?

[brend]

Probably first read is bad because you have this problem .
I think immo in dash , but you can check this you self , start car without dash and you will see .

[KarlEstoni]

Probably immo in dash is what i believe also, but what would be the options to fix when the first read was bad?

[brend]

Probably immo in dash is what i believe also, but what would be the options to fix when the first read was bad?

New one eeprom and repare key and sunhro blocks if corrupted eeprom still start.

[Diagcar1]

Read again, post your file. Check if it soldered the right way.