Help! Memory error message when patching TM-5200D

[quookie]

Hi guys

Hope you can help! I have a TM-5200D (non super) and downloaded the latest patch. I followed the instructions by extracting the file and moving this it onto my USB stick. I kept the channel on a free-to-air channel and inserted the USB stick into my receiver then turned receiver on. I go on to doing the data transfer but as soon as I select the file, an on screen message comes up: "Memory error". I have tried a few different USB sticks to no avail.

Any suggestions?

Cheers
Q

[Manic01]

Factory reset and try again. Making sure you have the exact patch for your model ie non super. Save any settings before doing this.

[quookie]

Thanks for response. I tried full factory reset and scanned a few free to air channels. However, no luck with patch as same error message appears. Anything else I can try?

Cheers
Q

[dick b]

Thanks for response. I tried full factory reset and scanned a few free to air channels. However, no luck with patch as same error message appears. Anything else I can try?

Cheers
Q
try formatting the stick 1st in the box its fat32(what ever that means)

[quookie]

How do you format the memory stick in the box? If you mean my USB memory stick, it is already FAT32. When transferring file, I can see the patch file but when selecting it, the "memory error" message appears. I have tried a few different types of memory sticks to no avail.

Cheers
Q

[hoggy952]

If you have a rs232 cable try patching with that,good luck.

[quookie]

Thanks hoggy952. As I'm a newbie to all this, can I double-check that I should use the same (latest) magicpatch file to do this via the loader, as you would by USB?

Many thanks
Q

[Manic01]

Yes mate...

[quookie]

Thanks for the advice everyone. I managed to patch my TM-5200D via the RS232 cable. As my box was not patched before, I could not patch via USB. However, after patching via cable method, I could easily load softkeys using the USB method.