Volvo XC40 R7F701330, problems reading?

[AB4S]

What programmers are people using to read this ECU?

I have CPT and unfortunately it never reads, i get the error "init flash fail"

I also have SMOK and i get "MCU Secured error"

I'm interested to see what programmers people are using to read this MCU and if they run into the same problems?

Best Regards

[superjet]

https://www.digital-kaos.co.uk/forums/showthread.php/932943-2018-VOLVO-S60-P31476261-AIRBAG-CLEAR-MODULE-HELP-NEEDED
what is it the parts number?

[AB4S]

https://www.digital-kaos.co.uk/forums/showthread.php/932943-2018-VOLVO-S60-P31476261-AIRBAG-CLEAR-MODULE-HELP-NEEDED
what is it the parts number?

For example i have one here part number "P32315772" which i am unable to read the MCU for some reason with CPT or SMOK. For the reason i am not sure. But the past 5 modules of this type and same MCU i am unable to read.

Thanks

[hacper]

XC40 from 2020 are secured, not possible to read.

[AB4S]

XC40 from 2020 are secured, not possible to read.

Bad news then for customers lol

[maucontacto]

Hi!!

REading ok with x-Prog but hangs when writing :(

[cange]

hi, still no solution for this mcu to read write safely on volvo srs module?

[AB4S]

I figured out how to clear crash via OBD on bench

[fuzz1]

I figured out how to clear crash via OBD on bench

Hi
Do you mean through can lines?

[AB4S]

Hi
Do you mean through can lines?

Yes, in this case the ECU is ran on FlexRay.

1015107

[bmwspec]

I figured out how to clear crash via OBD on bench
and what is the answer? people write everywhere forums are made to help each other

[AB4S]

and what is the answer? people write everywhere forums are made to help each other

I help people with files, i don't spoon feed people.

I'm showing people its possible

[slick_dick]

always possible with a little bit of hard work,

good job that man :)

many regards

slick

[bmwspec]

I'm showing people its possible

sure is possible with help of china people , here is spoon for everyone , will share some spoon - its obd50

[slick_dick]

sure is possible with help of china people , here is spoon for everyone , will share some spoon - its obd50

not the best tool to be using, many bricks have been produced by this programmer especially by obd

[AB4S]

sure is possible with help of china people , here is spoon for everyone , will share some spoon - its obd50

I use SMOK UHDS, actually.

I also meant showing it's possible to connect to flexray ECU on bench, not the clearing crash data.