Renault Master Tachograph off

[piem]

Hi,

My renault master 2 ph3 have tachograph off and dont show mileage in instrument cluster..
I think the best solution to resolve this problème is flash my uch with a dump whithout tachograph

then i'm looking for a dump for my HCH without tachograph

UCH-N3 P8200584665 --P V6,7
dash : P8200467948--D V4,7

Thanks a lot!
Piem

[piem]

Hi!
I have find the soluton whithout dump!

If you have the same problème you can do that: (from MR414X7083A000)

METHOD: Ignition off
● Disconnect the battery for at least 1 minute then reconnect it.
● Connect the diagnostic tool and establish dialogue with the UCH without switching on the ignition. ● Carry out configuration of the UCH (CF719) and chose ABS système or gearbox sensor
● Switch the ignition on and off to enter the new parameters.

If you have Renolink tool:
-Disconnect the batterie 1min
-reconnect the batterie
-connect Renoink (without switching on the ignition)
-chose your véhicule and UCH and clic "connect"
-for me it's like that:
863110

-Chose the configuration and clic "write" (take care to other configuration don't change befor write)
-disconect Renolink
-Switch on the igition and off to enter the new parameters
-Done

Piem