Honda 77960-T5C-J830-M1

[fuzz1]

Hello
I am looking for some help to clear this airbag module from a honda fit/jazz

77960-T5C-J830-M1

EEPROM 5LCA read with UPA as ST95640

Thanks

[motorin]

Try and report pass in pm

[dmka]

100% clear

[fuzz1]

Thank you all. The car is not with me I will try and report

[fuzz1]

Hi

the files i got from both are exactly the same
However i tried and giving me 4 faults same as before clear.

PERMANENT DTC

B0001-12 open or increased resistance in the driver's airbag first inflator
B0010-13 open or increased resistance in the front passenger's airbag first inflator
B0070-13 open or increased resistance in the left front seat belt tensioner
B0072-13 open or increased resistance in the in the right front seat belt tensioner

Could someone please have a look?

Thanks

[dmka]

I've used my file many times and it works. For the last 2 codes check buckles, they go bad in any type of accident. For the first 2 check connectors. Were you the one that replaced the airbags? NEVER trust someone else's work.

[fuzz1]

Hi
No it wasn't me who replaced the airbags and the seatbelts. But the guy who did is very very good. Difficult for him to get all four bad. Now I'm doubting myself.
Could it be i wrongly soldered back a leg? Would that be a possible cause?

Thanks

[dmka]

Wrongly soldered legs, most likely, will show an "internal fault" code

[fuzz1]

Wrongly soldered legs, most likely, will show an "internal fault" code

That's what i think too. Think I'll try to read the chip again. Thank you again.

These Honda sometimes are strange. Same solution for exact ecu gives different outcome. Had one where you get warning goes off but airbag light stays on and no dtc. Same solution worked on another car. Making me think it's because of different options on the car

[Tariel]

You cleared file. Pass in PM.

[Sandeepa]

Hey buddy
If you can try, just remove the seat belts from the vehicle body and let their couplers connected. Then try to clear the dtcs. These seat belts sometimes make problems in old cars.
Thanks and take care
Sandeepa

Sent from my vivo 1723 using Tapatalk

[fuzz1]

Thank you all
Worked fine. You were right the guy took a short cut and replaced it with resistors to check. Problem went away with the right airbags.

[adielektro]

Helo, I have the same problem too, please help me. Honda Jazz 2016 77960-t5a-s011-m1 TRW

[fuzz1]

Hi
My friend this is not same module. I will try to clear for you. Let me know if it worked. You should have started another thread better luck

[fuzz1]

Try this. pass in your pm

[adielektro]

A lot of data cleared, neox does differently. I also cleaned less. I'll check and let you know. Thank you

[fuzz1]

Ok let me know if it doesn't work I'll manually clean it for you. Why haven't you tried the other solutions though?

[jave735]

Hello
Here is my solution.

I will only send password if you ready to write it and report the solution whether it worked or not.
Let me know if you interested to try I will send password.

[adielektro]

A lot of data cleared, neox does differently. I also cleaned less. I'll check and let you know. Thank you

[fuzz1]

Hi
Which one worked?

[adielektro]

jave735
- thanks, work perfekt