Mollerdiagnosti
26th January, 2022, 01:31 PM
Hello
I have the same problem with audi a4 high pressure pump adaption.
Audi A4 2.5 (BDG) 2006 , not Start after injection pump replacement(starts and then dies)and fault code in the engine 17978 - Engine Start Blocked by Immobilizer
Ecu - 0281012142 /8E0 907 401 AF
Ecu - Edc15 VM+ & 24C04+29F800BT
Dash - RB8
Change VP44, and not posible adapt chanel 50, pin ecu login ok, but not posible adapt VP44, "system not in order". And the injector pump is from similar car and the spare part code is the same.
Dash - RB8 -
Is it possible make make immo off?
I have tested immo off on the 24C04(in attachment). After writing the immo off in eeprom I connected the computer on the table and I see in the immo is disabled (status 1). Now I but the engine ecu back to car and after that I see that still fault code in the engine: - Engine Start Blocked by Immobilizer. And if I check the immo status on channel 91 I see that immo is adapted.... strange for me.
I think the immo off has to be done in the flash: 29F800BT ?
In attachment flash read by mpps and eeprom ori and eeprom immo off. I also tried to adapt the high pressure pump online. But same problem as with vcds.
Can someone please help me ?
Thanks in advance
Tonu
I have the same problem with audi a4 high pressure pump adaption.
Audi A4 2.5 (BDG) 2006 , not Start after injection pump replacement(starts and then dies)and fault code in the engine 17978 - Engine Start Blocked by Immobilizer
Ecu - 0281012142 /8E0 907 401 AF
Ecu - Edc15 VM+ & 24C04+29F800BT
Dash - RB8
Change VP44, and not posible adapt chanel 50, pin ecu login ok, but not posible adapt VP44, "system not in order". And the injector pump is from similar car and the spare part code is the same.
Dash - RB8 -
Is it possible make make immo off?
I have tested immo off on the 24C04(in attachment). After writing the immo off in eeprom I connected the computer on the table and I see in the immo is disabled (status 1). Now I but the engine ecu back to car and after that I see that still fault code in the engine: - Engine Start Blocked by Immobilizer. And if I check the immo status on channel 91 I see that immo is adapted.... strange for me.
I think the immo off has to be done in the flash: 29F800BT ?
In attachment flash read by mpps and eeprom ori and eeprom immo off. I also tried to adapt the high pressure pump online. But same problem as with vcds.
Can someone please help me ?
Thanks in advance
Tonu