Kess v2 clone ECU missing!!

[skikkio]

hi guys, in recent days I decided to delete the dpf in a kia rio 1.1 crdi of my property, I use kess v2 clone as hardware, and precisely on this I have problems, I state that I have not disassembled the ecu, but the ksuite software 2.80 gives me for this car and this engine only Bosch ecu, when this should mount DCM3.7. if I proceed with just reading the ID of the ecu by setting BOSCH it gives me an alarm clock error, while if I put another car with the DCM3.7 control unit the reading of the ID is successful .... my question is: there are no protocols in my software for this car or can I even proceed with reading / writing by putting another car from the software? thank you in advance

[blackpirate]

you got lucky!
dont play with that clone on that ecu.

[alonedark]

Yes works ok one friend have one machine this and do ir this car ok

[EngineGen]

You can easily select 3.7 from the PROTOCOLS tab and read/write the file.

[skikkio]

so I can groped to read the file by setting another car?