OPEL ASTRA H ---- DISPLAY SAFE

[latino]

Hello i have a display that is not from the car (original burne). i write vin code manualy and in the code adress ,manualy i put fff now i think is prepar for pair

i read eprom from car 25c32 and i have ori (pin 1996 ) code from the car

with op cpom i try pair (radio display ) but without sussec . can some one explain if i need to put my eprom from the radio unregistered then i can programme to the car?

i post the eprom from used display & original eprom from rádio , apreciate any help .thanks

[latino]

if possible need eprom 24c32 unregistered. thanks

[catastefan]

if possible need eprom 24c32 unregistered. thanks

Virgin dump atached.....pair with display code...pay attention to MID Speed CAN config

[shooting]

Hello i have a display that is not from the car (original burne). i write vin code manualy and in the code adress ,manualy i put fff now i think is prepar for pair

i read eprom from car 25c32 and i have ori (pin 1996 ) code from the car

with op cpom i try pair (radio display ) but without sussec . can some one explain if i need to put my eprom from the radio unregistered then i can programme to the car?

i post the eprom from used display & original eprom from rádio , apreciate any help .thanks

If both Displays are the same model then just use original dump in new display...

wbr

[shooting]

Use BOTH these dumps and pair using 1996

wbr

[latino]

Hello catastefan , i check Mid speed is same conf radio and display , now display say radio safe and in 2 and 2 sec bip..bip..bip

i activate thetf protection with ori pin code in this case 1996 i have the info ( the programming was finished successfully )
tun off the key 2 mint and have the same radio safe ...bip...bip..

i try deactivate teth protection to try programming again with same pin code and alway have the info ( programming fail )

i use shooting dumps programming and everything is ok .thanks you

[latino]

hello shooting i use your soluction and everithing go great-thank you