BMW e60 530d edc16c31 HW: 0281011224 SW: 1037390908 VIN nr.: WBANC72010B331013

[valek4400]

Hello

Could Anybody help with map locations with my car?

I built a E60 530d 211hp engine into a E36.
The engine ecu is turned into "emergency mode" because it not receive speed signal via can-bus.
I built speed signal generator for the ecu,but i can connect it only to the direct speed signal line.
Now the engine fault memory throws a can-bus speed signal error and won't rev up to 5000 rpm just to 4000.

I attached the flash dump

Thank you!

Regards

[Lambda1]

looks for EngPrt_trqNLim
For your VehDa_rVn problem... there isnt a values which is used, its allways based on VSSCD_v and Eng_nAvrg also if there isnt singal for it calcs it.

[VollPower]

Try your RPM Limiter maps, looks it stays on the lower RPM limits. So look for the RPM limiters and you will find the 4000rpm
Can be your Limpmode RPM limiter. just change that one to max RPM limiter from engine. and i guess it will work.
if it still gives the DTC but Rev up normal. Remove DTC