Renault Siemens Sirius 32N Immo off

[barth71]

Hi I tried immo off ( with emulator ) in ecu Siemens Sirius 32N with CAN
I read this ECu in boot mode with KTAG on bench and try virginize with instruction from emulator.
Then say : put FF FF FF FF between 4000 to 7FFF when forun "54 D7" or " 64C7" .
But in my read in this area is all FF.
Please help me is this possible immo off with emu and with this read?
Renault scenic I RX4 2.0 16V
ecu number S110110228
8200048226

thanks for advance

[kowal5]

Is this automatic transmission?

[barth71]

Hi
No this is manual gearbox.
Regards

[barth71]

Somebody tell me if this possible immo off with this read ? without emulator?

[IMM0killer]

Renault Siemens Sirius 32N Immo off (https://www.digital-kaos.co.uk/forums/showthread.php/947465-Renault-Siemens-Sirius-32N-Immo-off)

press thanks and give rep

[barth71]

Hi thank you for your help but this solution not work.

Because I have a problem. I have a two ECu's SIRIUS 32N with CAN (controler CAN onboard) nr. ecu: 8200048226This is REnault scenic I lift. 2.0 16V petrol
I try first ECu read Ktag and write IMMO Off file with KTAG but not succes.
I'll try second ECU read Am29f200BB in programmer , make virgin and use emulator but no succes.
Please help me whats going on because I have cable on a pin58 and I have cable PIN 26 and 56 CAN.
What I must to do because I'm Confused.
Below I upload My orginal file from KTAG from First ecu
And i upload My orginal filre from programmer and my virgin .
Maybe somebody know where is the problem
thanks for advance

[IMM0killer]

if your ecu is can then only emulator can help.

[barth71]

Hello. I understand you are right. But can you help me with this because I made my programmer file on Virgin, I put on an emulator and it didn't work. Is my virgin file good? Should I cut off the two CAN lines and pin 58?