Hardcut EDC16c35

[Cascais94]

HW: 0281013501
SW: 1037389882
SW upg.: 07809483


Hello , i already made this Stage 1 file for my e91 touring. Runs great almost smoke free.
But can't do hardcut while stationary .
Tried to but just does while driving ( Manual GearBox) .
Can someone help me with it and check if my file is good ?


Thanks.

[capkin92]

HW: 0281013501
SW: 1037389882
SW upg.: 07809483


Hello , i already made this Stage 1 file for my e91 touring. Runs great almost smoke free.
But can't do hardcut while stationary .
Tried to but just does while driving ( Manual GearBox) .
Can someone help me with it and check if my file is good ?


Thanks.



try and reportt

[Cascais94]

try and reportt

Thanks!! will try it tomorrow morning

[Cascais94]

Thanks for your time but still wont pass 4k while stationary .
Any hint ?

[afonsitoamd3]

try and reportt
Skype: alfonsorico96
https://mega.nz/file/H6YjjSDK#eR8E7kAD6MWubBh8PJkiVS27DmeIbNurCJfayZhBR 3I
if it's not strong, I can send a v2

[Cascais94]

try and reportt
Skype: alfonsorico96
https://mega.nz/file/H6YjjSDK#eR8E7kAD6MWubBh8PJkiVS27DmeIbNurCJfayZhBR 3I
if it's not strong, I can send a v2


Just tested it and thanks for your time and effort but it still doesn't hardcut in stationary it still gets stick at 4 krpm i think its some protection feature this model has to just go max rpm while running .
you set the hardcut to 4900 ? can't reach that rpm so it doesnt hardcut .
Thanks for the help in this quest :peaceful:

[Cascais94]

anyone know the SVRL map adress at this FIle ?
Thanks

[alonedark]

porropones for you

[Cascais94]

porropones for you

still no hardcut can you change it to 4500?
Thanks for your help .

[alonedark]

Yes I can do

[alonedark]

It’s very easy no??

[skiera]

Corrected st1 + hardcut 4600

I know address for single value rev limiter :) if you won't be satisfying i'll change


@edit if you give me ori file i can make you correct stage 1 :)

[alonedark]

but man if that is very easy look I explain it in hexadecimal, the original value is 5250 1482 in hex and l change for 4500 in hexadecimal 1194 and this is already you have hard cut

876127

[alonedark]

you have here , 876128

[Johnsy1998]

You need too find the neutral gear limiter for popcorn on stationary.. I will see if I have it :)

[marko6jpt]

here for u

tnx+rep 4 pass

876145

[alonedark]

Have change 4000 to 5200 too

[Cascais94]

you have here , 876128

Thanks for all your help

[ZachuRaz]

hi. I have same problem, cant het Hardcut works on 118d revs just hit 4000 on neutral. could you help please.
HW: 0281013502
SW: 1037389883