Peugeot hybrid

[Max79]

Hello, there is a problem.
I am writing from Ukraine through a translator.
I have two cars Peugeot 508 hybrid 2014 and Peugeot 3008 hybrid 2015. I know for sure that there was a mileage adjustment. The car runs, drives, the hybrid system works as it should, but the car constantly goes into emergency mode.
This may be when shifting gears or at slightly higher engine speeds. I tried to do online telecoding and teleloading - the hybrid system is not updated.
- I think that through online access there is a blocking of the BSI block.
- or the block firmware is broken
- there are no such problems on old blocks until 2014.
-
two different cars and on different blocks 3008 BSI, Peugeot 508 BSI 2010 - the errors are completely the same.
Has anyone had the same problem, how did you solve it?
Thanks

[marina_rv]

read flash BSI and send to forum.

[Max79]

read flash BSI and send to forum.

This is a flash for the hybrid Peugeot 3008, please see what's wrong with it, if possible, make a correction for 185,000 kilometers.

[Max79]

This is a flash for the hybrid Peugeot 508, errors on two cars occur mainly when switching from first to second gear, the adaptation was done, keeps going well, as soon as the BSI falls asleep, the errors are the same again. thank you

[marina_rv]

FLASH BSI2010 508 2014 Hybrid.bin = BSI by Continental

FLASH BSI 3008 Hybrid.bin = BSI by JC
add 8002 = 00 <---- change

[Max79]

FLASH BSI2010 508 2014 Hybrid.bin = BSI by Continental

FLASH BSI 3008 Hybrid.bin = BSI by JC
add 8002 = 00 <---- change


Hi, that's right.


The problem is that I diagnose and repair cars, and the correction is not my specifics, these two cars were brought to me after the correction, and until 2014 in hybrids there is no such problem, everything is well repaired. If possible, please correct and explain what exactly is changing in this case - is it unlocking?
thank you