MadridEcu
4th May, 2022, 04:09 PM
Hi mates,
Project: I built a homemade 220V generator using a 206 HDI engine, I need modify idle 1700 RPN with max torque ( if posible)
The problem is that in previous mod file only keeps 1700rpm for exactly 10 Min, then goes to 800RPM.
P0500 is shown in diacgnostic tool and i assume is a DTC related to this fault , Then I deleted it in flash in a new mod file but the problem was not solved and go to 800 rpm again .
I have a new ECU, could someone modify my new ori file with 1700 RPM idle and maximum torque and take into account this problem (go down to 800RPM after 10 min) ?
I attached the new ori file (read with Ktag clone).
I have another thread related to this but a long time ago, so i decide write a new one .
Best regards
Project: I built a homemade 220V generator using a 206 HDI engine, I need modify idle 1700 RPN with max torque ( if posible)
The problem is that in previous mod file only keeps 1700rpm for exactly 10 Min, then goes to 800RPM.
P0500 is shown in diacgnostic tool and i assume is a DTC related to this fault , Then I deleted it in flash in a new mod file but the problem was not solved and go to 800 rpm again .
I have a new ECU, could someone modify my new ori file with 1700 RPM idle and maximum torque and take into account this problem (go down to 800RPM after 10 min) ?
I attached the new ori file (read with Ktag clone).
I have another thread related to this but a long time ago, so i decide write a new one .
Best regards