View Full Version : VW MFD2
cristinuz
11th May, 2022, 03:46 PM
I need code mfd2.Thankyou
wiechec
11th May, 2022, 03:48 PM
You have to read FIS as 24c32.
shooting
11th May, 2022, 03:49 PM
I need code mfd2.Thankyou
Your code is 0148
wbr
masterskay62
11th May, 2022, 03:49 PM
I need code mfd2.Thankyou
Hi. The code is FIS. Read FIS and provide firmware here
cristinuz
13th May, 2022, 05:35 AM
The code is not good. I tried to read Fis with Orange5, now the drive does not start.
Is there a solution to work again?Still didnt find a solution to this, can't read dump (i get all zero's) can't write a file (stays all zero's), and the unit does not power up.
any solution or i should replace the whole unit?
shooting
13th May, 2022, 06:27 AM
The code is not good. I tried to read Fis with Orange5, now the drive does not start.
Is there a solution to work again?Still didnt find a solution to this, can't read dump (i get all zero's) can't write a file (stays all zero's), and the unit does not power up.
any solution or i should replace the whole unit?
Code given was correct for serial provided, your problem was you probably just tried it on the bench and not the car.
Now you tried to read and had problems so you tried to write, this was a mistake, now you have a brick.
You need firstly to try in the car with my code, then if this does not work you need to re-flash it with the correct dump. (Because you incorrectly flashed it)
wbr
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.