kubaK
23rd May, 2022, 07:50 PM
Hello, i had a Peugeot Partner, which i flashed a file onto via OBD with Flex. After a couple of days i had to reflash the ECU for some changes.
As always stablilizer connected, followed ignition on off procedure. But the car has fallen asleep around 99% of the write procedure. Which resulted in failure of writing. The error that it says is "Writing Coding Error" when it hits 100%. Car wont start.
After some time with MMS support, opening the ECU in boot mode and checking the flash, the flash appears to be 100% correct but the car has lost coding.
Any way to restore that? or it is a possibility to get a second hand ECU with same HW numbers and write the EEPROM from the original ecu to the used one?
If anyone is interested in maybe looking at the full backup of the ecu, i am willing to share that.
As always stablilizer connected, followed ignition on off procedure. But the car has fallen asleep around 99% of the write procedure. Which resulted in failure of writing. The error that it says is "Writing Coding Error" when it hits 100%. Car wont start.
After some time with MMS support, opening the ECU in boot mode and checking the flash, the flash appears to be 100% correct but the car has lost coding.
Any way to restore that? or it is a possibility to get a second hand ECU with same HW numbers and write the EEPROM from the original ecu to the used one?
If anyone is interested in maybe looking at the full backup of the ecu, i am willing to share that.