View Full Version : Siemens SID803A - compatibility
viktor0221
25th June, 2022, 08:46 PM
Hi,
I would like to know if those ECUs below are interchangeable or not. I would like to make sure that the spare ECU which I'm planning to buy will be able to be adapted properly.
Original ECU:
SID803A
5WS40614B-T
SW9664611280
Spare ECU:
SID803A
5WS40899A-T
SW9667115080
They are also in the attachment.
Thanks a lot!
elektronik325
25th June, 2022, 09:11 PM
Hi. Yes, with Sid803 and 803A, no problem, you buy any ECU, upload the full bdm reading and it works without a problem. Best regards
viktor0221
25th June, 2022, 09:25 PM
Thanks!
The problem is that I have no ori BDM read, since ECU is completely dead.
I can transfer eeprom and flash phisically too, but what is the chance that I don't need MPC to swap between two above?
Thanks a lot!
zetecnology
26th June, 2022, 04:07 AM
the HW hardware codes are the same so this should work and if i remember right on sid803a maps are in flash not mpc, but in sid803 maps are in mpc
Lambda1
26th June, 2022, 08:34 AM
flash and eeprom is enough if both ecus same numbers.
viktor0221
26th June, 2022, 09:39 AM
Unfortunately they have slightly different numbers. You can see them above. This is why I am not sure if they can be interchanged.
EDIT: it works, thanks for the comments.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.