BSI04EV2 KE4-00 can not read 95128

[credoline]

Hi friends.I can not read eeprom from C5 BSI. Only one 8 pin chip have pin 4 on GND and pin 8 on Vdd and its near SPC560 and pins are connected to SPC560. When i try to read him with BEEprog or with XprogM whatever i select this chip M95128 or ST95128 or as 25128 always get message that pins 3 and 7 are not connected. But BSI still working after my trying and i can read and erase DTC-s.
Any advice how to read ?
Thank you

[metercar]

you desolder eeprom from pcb?

[Bllinda]

maybe before that, the masters forgot to solder the SPI chip.


you desolder eeprom from pcb?

https:/ /www.digital-kaos.co.uk/forums/showthread.php/740526
https:/ /www.digital-kaos.co.uk/forums/showthread.php/824288

[credoline]

Yes, chip was detached from board. Anyway this bsi have one problem and i am try to get pin code. I have another one used bsi without this problem and need to code him.
At the end i am success to read chip in circuit successfully and get pin code. In circuit read okay, off board not want to read. I was try to read full original bsi with IO terminal and Smoke but not want, replacement bsi read okay. And i am give up from cloning, must do manually.


you desolder eeprom from pcb?

[metercar]

For this BSI the best way is coding with Diagbox offline manualy and two drink's

[credoline]

Without data from old bsi about coding settings very, very hard to set coding data right. It have about 100 items and some item have 7 possibilities for settings. Example: altenator have 5 types, how you can now which one is right one?


For this BSI the best way is coding with Diagbox offline manualy and two drink's