E60 530d Dashboard dead

[avtonega]

Hi

My costumer had dead batery in his E60, then he used booster to start the engine , and after that, dashboad was dead.
-Mileage is counting OK
-RPM, speed, fuel gauge, consumption, outside temp. are dead
First I have scan viechle with KTS, and no live data was shown RPM-zero, Out.temp.-76, fuel guge - zero...
One ERROR is present: CAN-BUS comunication is dead

Then I found 2nd Dashboard from other E60. It works fine, but there is one RED dot in the end of mileage.

I have opend both clusters, read both M35080 (attached), and swap them eachother.
Mileage is OK, red dot is gone and for first 5 seconds needels are working, and then cluster goes OFF, and I message appears on board computer (attached)
And DTC si present: dashboard fault
All live data are OK

Any idea anyone?

[simon77]

try to re-code the clocks with ncs or sss should sort it out.

[avtonega]

Resolved

I have use dump from second dashboard, and:
ADJUST KM & VIN

[drpeter]

Resolved

I have use dump from second dashboard, and:
ADJUST KM & VIN


Good, how did you changed the VIN?

[PremierD]

Good, how did you changed the VIN?

With Hexworskhop I would imagine mate.....

Post A dump....

[avtonega]

You will need Hex-editor on such things



:wink:

[peko]

hi,

and don't have any checksum ?
but not forget reset DTC save in CAS