View Full Version : cummins VP44 tester
aktiv22
25th February, 2010, 10:37 AM
hi
have someone cummins VP44 tester ?
highline
12th March, 2010, 09:25 PM
Please:wink:
aktiv22
12th March, 2010, 09:48 PM
sorry this tester
skiller_1
13th March, 2010, 12:36 AM
what kind of interface must be used. thx
aseermrmr
13th March, 2010, 12:46 PM
sorry this tester
much thanks
highline
13th March, 2010, 01:19 PM
simple OBD interface
gustpe
2nd July, 2010, 05:59 PM
YouTube - Simulador Vp44 simulador vp44
RSwire
4th July, 2010, 05:22 PM
Can I use an IC4 interface on larger vehicles without OBD connector? thanks.
dimitar22
4th July, 2010, 06:44 PM
Please tell which obd interface and which cables, where to buy them from.
Thank you in advance.
zoro1
31st October, 2010, 09:55 PM
what kind of interface must be used. thx
KL/COM !!or VAGCOM , USB VAG!
RSwire
31st October, 2010, 10:19 PM
Can someone post a pinout for this tester( vp44 to obd) the one in the soft isn't in english and I don't want to get it wrong. And I hook right to the vp44 correct? And the interface needs to be serial port not usb?
Poptest
1st November, 2010, 11:17 AM
Can someone post a pinout for this tester( vp44 to obd) the one in the soft isn't in english and I don't want to get it wrong. And I hook right to the vp44 correct? And the interface needs to be serial port not usb?
I use Bosch test cable 0 986 612 447 and connect it between PSG and PSG harness. KTS reads through vehicle OBD socket.
Pump alone can be tested with this cable. You have to power up pins 6(-) & 7(+).
In both cases, KTS can do fault readout, and also read voltage, current, and waveform patterns through the adapter's 9 pins.
37075
37076
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.