kakkak66
25th February, 2010, 12:39 PM
I have a car (VW POLO 1.4 2002) magnetimarelli iaw4mv.td
It does not start. The immo lamp is blinking.
01177 Fault code - Engine control module not authorized Engine control module not matched.
The Car was at a serviceman just for look it around and check the car. The owner got the car back from the VW dealer with an ECU failure and they sad "ECU has to replace". The car was working before the all stories. The diagnosis of the dealer was 360 EUROS. They did not fix anything.
After these stories I got the car.
So I need the login codes for match the ECU with the instrument cluster.
I desolder-ed the 95080 eeprom. I redid it. I tried with two programmer (superpro 3000, Upa). Same result. The superpro wrote the eeprom protected. But the verify was succeed. I think the dump is not OK. Because no chassis number in it.
I was thinking maybe need I use something code in the upa programmer to get the right dump? Or somebody can give the login code from it.
It does not start. The immo lamp is blinking.
01177 Fault code - Engine control module not authorized Engine control module not matched.
The Car was at a serviceman just for look it around and check the car. The owner got the car back from the VW dealer with an ECU failure and they sad "ECU has to replace". The car was working before the all stories. The diagnosis of the dealer was 360 EUROS. They did not fix anything.
After these stories I got the car.
So I need the login codes for match the ECU with the instrument cluster.
I desolder-ed the 95080 eeprom. I redid it. I tried with two programmer (superpro 3000, Upa). Same result. The superpro wrote the eeprom protected. But the verify was succeed. I think the dump is not OK. Because no chassis number in it.
I was thinking maybe need I use something code in the upa programmer to get the right dump? Or somebody can give the login code from it.