View Full Version : kia
mohamad1401
4th August, 2022, 06:16 PM
hi all
please i need clear crash airbag Kia rio 2019
continental 95910 h9210
eeprom 95512
micro R7F701193
thx
semsem
4th August, 2022, 06:26 PM
Bad read
read mcu again
mohamad1401
4th August, 2022, 06:48 PM
thx here ...
boxsport
4th August, 2023, 05:47 PM
thx here ...
hello there. I need to reset the same module.
Could you tell me what programmer did you use to read it?
Do you know if UPA-S or VVDI Prog can read it?
fuzz1
4th August, 2023, 06:02 PM
You can put the pictures on here. Higher probability of getting helped
boxsport
4th August, 2023, 06:14 PM
You can put the pictures on here. Higher probability of getting helped
Here are some pictures of this module.
gwiazdamb
4th August, 2023, 08:10 PM
Please
Kia R7F701193
CPT UPA
1 ....7
2 ....9
5 ....3
6 ....2
7 ....8
9 ....5
boxsport
4th August, 2023, 10:49 PM
Please
Kia R7F701193
CPT UPA
1 ....7
2 ....9
5 ....3
6 ....2
7 ....8
9 ....5
Great...
Cheers Mate....
fuzz1
5th August, 2023, 05:31 AM
Hi
When you verify the read with UPA you will end up with errors. I stopped there. But heard it doesn't matter. Clearing the file and writing it back will work. Let us know if you successful with UPA.
boxsport
5th August, 2023, 07:01 PM
Hi
When you verify the read with UPA you will end up with errors. I stopped there. But heard it doesn't matter. Clearing the file and writing it back will work. Let us know if you successful with UPA.
I just read this module with Renelight and it worked perfect. No errors.
I leave here the Pinout i used. Had to use 3.3V
Also, can anyone help me out clearing crash on this file? Eeprom for what i read i just need to put all FFs and write.
Thanks
fuzz1
6th August, 2023, 03:53 AM
Yes FF in eeprom.
Would it be possible to read it with UPA too and compare?
boxsport
7th August, 2023, 06:08 PM
Yes FF in eeprom.
Would it be possible to read it with UPA too and compare?
hello there.
The UPA programmer is from a friend and since i coulnd have is laptop, i was not able to "activate" the software in my laptop to test.
And for what i have read, readings with UPA on this MCU will give always different readings.... But i also read that reading with UPA, cleaning file and write with UPA will work...
To be honest, i liked a lot using Renelight because it had no errors and it was quick reading and writing...
I used an online webpage to clear file and it worked good, cleaning MCU D-Flash and eeprom all FF´s.
Thanks for the support...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.