View Full Version : Mini Cooper mevd
dd1
18th August, 2022, 12:17 AM
Hello everyone. I have swapped a Dme for a Mini Cooper manual transmission, the dme was used and from an automatic trans. I have cloned it, the car started fine, vin is ok too. But the only thing is that the check engine comes on with a fault code for EGS, apparently the Dme is looking for an EGS. I have cloned it with the KTAG. Any suggestions? Or what tool do I need to get this error taken out?
ricked
19th August, 2022, 09:35 AM
with bmw/mini best is to get exact same ecu, if not you can expect these problems
so in short, dont use bosch replacement list
dd1
19th August, 2022, 07:23 PM
with bmw/mini best is to get exact same ecu, if not you can expect these problems
so in short, dont use bosch replacement list
I’m using the same part numbers. But why is cloning not doing the job? No other way to correct this issue?
ricked
19th August, 2022, 08:28 PM
error code and bosch number and what is the reson you did you need to replace it?
dd1
19th August, 2022, 09:52 PM
error code and bosch number and what is the reson you did you need to replace it?
Internal control module fault code. The used unit is fine, except for the EGS code
bauvaisis
19th August, 2022, 10:03 PM
Hi, what kind of ecu do you have? What's your mini model and year ?
Envoyé de mon ELE-L29 en utilisant Tapatalk
bauvaisis
19th August, 2022, 10:05 PM
You should try coding ecu with correct VO taken from the CAS
Envoyé de mon ELE-L29 en utilisant Tapatalk
dd1
20th August, 2022, 12:17 AM
You should try coding ecu with correct VO taken from the CAS
Envoyé de mon ELE-L29 en utilisant Tapatalk
How can I do this and what tools are needed?
bauvaisis
20th August, 2022, 06:15 AM
Depends what mini you have..
If it's châssis R, you need ncs expert.
If it's châssis F, you need esys
Or any other good quality diagnostic like launch, autel for example
Envoyé de mon ELE-L29 en utilisant Tapatalk
dd1
20th August, 2022, 03:41 PM
Depends what mini you have..
If it's châssis R, you need ncs expert.
If it's châssis F, you need esys
Or any other good quality diagnostic like launch, autel for example
Envoyé de mon ELE-L29 en utilisant Tapatalk
It’s a R and I do have the NCS
bauvaisis
21st August, 2022, 02:40 PM
Cool, than try that out first :)
Envoyé de mon ELE-L29 en utilisant Tapatalk
dd1
22nd August, 2022, 11:16 PM
Cool, than try that out first :)
Envoyé de mon ELE-L29 en utilisant Tapatalk
i have tried autologic and autel, no luck. the code is not going away.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.