EWS Editor Help!

[FAL]

http://i769.photobucket.com/albums/xx339/Dean_B/EWSEditorReadPoint-1.jpg

I'm using EWS Editor and i've just opened an EWS 4 box for the first time. Can anybody tell me were the reading initialization point is, please?
Thanks,
FAL

[cjawahir]

what i can tell you the EWS 3 test point is pin 22 -- mob

so maybe you can get a pinout of the ews4.3 chip .

cj

[FAL]

http://i769.photobucket.com/albums/xx339/Dean_B/MC9S12D64CFU.jpg
Pin-out for Freescale MC9S12D64CFU, used on the EWS 4.3 i have. If anybody can point out the correct pin, it would be a graet help!
Thanks,
FAL

[cjawahir]

l think its pin 23 not 37 , so take care

[cjawahir]

I look at it again looks like pin 23

pin 23 is is the square dot in the center of the board , there are six dot close together use the square one .


cj

[cjawahir]

here is the square pin .

in the picture

http://img19.imageshack.us/img19/9971/ewss.jpg (http://img19.imageshack.us/i/ewss.jpg/)

[tachonow]

You need Cas3 programmer Rosfar R260 for reading EWS4.

[cjawahir]

EWS editor can now read the 4.3 ews , with new software .

cj

[FAL]

Thank you CJ!
Has anybody got the EWS Editor (EWS 4 - Version 3.2.0) software update, please?
Thanks,
FAL

[cjawahir]

EWS Editor Light ? AVTOTOOLS (http://www.avtotools.com/index.php?productID=121)


cj

[marius_d_2002]

I downloaded EWS Editor 3.2.0 but I can't open any bin file. I use tntenforcer but no result. Can anybody help me.

[dreadu]

has anybody tested the ews 4 reading touch point with ews editor?? i dont want to kill my ews 4.3 hw 06. The seller says to me it can only be done like tachonow says. only the bin file can change with ews editor (the seller says to me).

[dreadu]

i can say you that it don'T work with ews editor i tried it today