View Full Version : Rover MGF MKC104000 93c46 / c66cm3 Immo Off?
jnc automotive
12th September, 2022, 05:04 PM
Had some issues trying to read the eeprom.
So may be corrupt :offended:
Can anyone provide immo off if good read?
If not, anyone have an originial.immo off?
Thanks
gwiazdamb
12th September, 2022, 05:48 PM
Had some issues trying to read the eeprom.
So may be corrupt :offended:
Can anyone provide immo off if good read?
If not, anyone have an originial.immo off?
Thanks
reading eeprom error
read 93c66
jnc automotive
12th September, 2022, 06:32 PM
93c66 16bit
I suspect another dodgy read.
Possibly corrupt.
gwiazdamb
12th September, 2022, 08:54 PM
93c66 16bit
I suspect another dodgy read.
Possibly corrupt.
JES
You read the clip ?, desolder and put into the programmer
jnc automotive
12th September, 2022, 09:09 PM
I tried as I normally do with the clip with eeprom off the board.
No luck so soldered onto the programmer direct.
jnc automotive
12th September, 2022, 09:10 PM
I have found eeprom data from another ECU. Can I immo off that to work with this ECU?
gwiazdamb
12th September, 2022, 09:25 PM
I have found eeprom data from another ECU. Can I immo off that to work with this ECU?
You can try, but you'd better keep a copy of it
jnc automotive
12th September, 2022, 09:29 PM
I have no idea if this will work. But it's all I have.
jnc automotive
12th September, 2022, 09:32 PM
This one might be a better match...
gwiazdamb
12th September, 2022, 09:48 PM
I have no idea if this will work. But it's all I have.
Before connecting the engine ecu !!!!!!!!!!!!!
Additionally, you need to cut off the immo code line from the ecu and lock the starter relay
jnc automotive
12th September, 2022, 10:06 PM
I already figured out the starter feed wires at alarm ECU.
I did read which wire to also cut from alarm ECU which I assume goes to Engine ECU.
jnc automotive
13th September, 2022, 08:38 AM
Unfortunately vehicle not fire with that.
Could try the 2nd eeprom read I uploaded?
jnc automotive
13th September, 2022, 06:52 PM
Ok, So I got a new ECU.
Here is the file.
Many Thanks
gwiazdamb
13th September, 2022, 08:02 PM
Ok, So I got a new ECU.
Here is the file.
Many Thanks
............................
jnc automotive
13th September, 2022, 08:20 PM
Thank you.
Which wire to cut for alarm line to ECU?
gwiazdamb
14th September, 2022, 06:43 AM
Thank you.
Which wire to cut for alarm line to ECU?
remove the alarm module
jnc automotive
14th September, 2022, 08:12 AM
Perfect, have bridged wires and removed module.
will try.
jnc automotive
14th September, 2022, 08:51 AM
So the car starts for 1 second.
jnc automotive
14th September, 2022, 12:37 PM
This is a read after i have plugged into car.
After writing your MKC ori_no file, if i read straight after, the bottom 2 lines change.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.